Updated
Lug width is the distance between the inside edges of a watch's lugs, and it tells you which strap width to buy. Measure it in millimetres across the spring bar, ideally with callipers. Most field and sports watches use 20 mm, though 18, 19, 21 and 22 mm are common too.
Get this one number right and almost any strap will sit neatly. Get it wrong by a single millimetre and you will see it every time you look at your wrist. Here is how to find it, what the common sizes mean and what to check beyond width.
What lug width means
The lugs are the four horns at the top and bottom of the case. The strap sits between each pair, held by a spring bar that runs from lug to lug.
Lug width is the gap between the inner faces of each pair. The end of the strap must match that gap to sit flush and secure.
It is easy to confuse with other numbers on a spec sheet. Case diameter tells you how wide the watch is. Lug-to-lug length tells you how far it reaches along your wrist.
Strap length is about your wrist size. Lug width is about one thing alone, the joint between case and strap.
For the overall fit on your arm, see our guide on how to measure your wrist for a watch.
How to measure lug width
You do not need a workshop. A few minutes and a steady hand are enough.
- Check the maker's specification first. Most brands list lug width on the product page or in the manual.
- Look at the back of the strap you already have. Many straps carry the width near the lug end, often as two numbers such as 20/16.
- If you need to measure, use digital callipers. Close the jaws gently on the inner faces of the lugs, just below the spring bar.
- Without callipers, hold a steel ruler flat and square across the gap. Read it straight on, at eye level.
- Measure twice. If the reading falls between two sizes, check again rather than rounding up.
The most common mistake is measuring across the outer edges of the lugs. That gives a number several millimetres too large.
Curved or tapered lugs can also mislead. They may look wider at the tips than at the bar, so always measure where the spring bar sits.
A strip of tape on the callipers' jaws protects the case while you work. Steel jaws can mark a polished or sandblasted finish.
Common lug widths
Most watches use even sizes, but odd widths are more common than many people expect. The table shows where each size tends to appear.
| Lug width | Where you often find it |
|---|---|
| 18 mm | Smaller and vintage watches, many dress watches |
| 19 mm | Some vintage pieces and a few modern brands |
| 20 mm | Field and sports watches of roughly 36 to 40 mm |
| 21 mm | Brands that prefer odd sizes for proportion |
| 22 mm | Larger sports and dive watches |
These are tendencies rather than rules. A brand can choose any width that suits its case.
Because 20 mm is so common, it has the widest choice of straps. Rubber, nylon, leather, canvas and bracelets are all easy to find in that size.
Odd sizes such as 19 and 21 mm give a designer finer control over proportions. The trade-off is a smaller choice of aftermarket straps.
Older watches can surprise you. Some vintage pieces use 17 mm or other unusual widths, so measure before you buy.
What happens if a strap is 1 mm off
One millimetre sounds small. Between the lugs, it is easy to see and easy to feel.
- A strap 1 mm too narrow leaves a gap of about half a millimetre on each side. It can slide along the spring bar, and the gaps look untidy.
- A strap 1 mm too wide has to be squeezed in. The edges bend, the strap sits unevenly and the spring bar becomes hard to seat.
- Soft leather can sometimes be eased into a slightly smaller gap, but it puckers at the edges. Rubber, steel and stiff nylon will not compress.
- Forcing a strap that is too wide can press on the lugs and mark the case.
The rule is simple. Buy the size that matches your lug width, not the nearest size you can find.
Taper is a different matter. Many straps narrow from the lug end to the buckle, such as 20 mm down to 16 mm.
That taper changes the look on the wrist, not the fit at the case. Always buy by the lug-end width.
Lug width and the look of a watch
Lug width also shapes how a watch looks on the wrist. Designers set it to balance the width of the case.
A wide strap on a small case looks sporty and solid. A narrow strap on a large case can make the watch look top-heavy.
Taper helps here too. A strap that narrows towards the buckle makes a watch look slimmer and lighter on the wrist.
A straight strap with no taper looks more rugged. Many field and military straps are cut this way.
That is why the same watch can look quite different on two straps of the same width. Width sets the fit, while shape and taper set the style.
Spring bars, thickness and other details
Width is the first check, but not the last. A few other details decide whether a strap fits well.
- Spring bars come in different diameters. 1.8 mm is the standard, with thinner and thicker bars for some straps and watches.
- Strap thickness matters at the lugs. A very thick strap can foul the case or refuse to sit under the bar.
- Bracelets and some rubber straps use curved ends shaped to one case. They rarely transfer to other watches, even with the same lug width.
- Drilled lugs have small holes through the outside. They make strap changes easier with the pin end of a spring bar tool.
If you are fitting a strap with classic spring bars, follow our guide on changing a strap with a spring bar tool. For choosing a material, see our watch strap materials guide.
Our watches and straps
Every KOMPAS watch has a 20 mm lug width. The case is 39 mm across, 46.5 mm lug to lug and 10.4 mm thick.
All four models share the same case and the same lugs. You can check the full spec on the South, which has a blue dial inspired by the open sea.
Each watch comes with a rubber strap and a nylon strap in the box. Both are 20 mm quick release, so you can swap them without a tool.
Our guide to changing a 20 mm quick-release strap shows the method step by step.
Because 20 mm is such a common size, most good 20 mm straps will fit too. Look for straps with standard spring bars and a sensible thickness at the lug end.
The G.L.C. × KOMPAS DPM Strap fits 19, 20 and 21 mm lugs, so it suits a wide range of watches. It uses classic spring bars and comes in its own box with a spring bar tool.
Frequently asked questions
Is lug width the same as strap width?
At the lug end, yes. The strap should match the lug width exactly, even if it tapers towards the buckle.
Can I fit a 22 mm strap on a 20 mm watch?
No. A strap 2 mm too wide will not sit between the lugs without bending, and forcing it can mark the case.
Can I use a 19 mm strap on a 20 mm watch?
It will fit, but it leaves small gaps and can slide on the spring bar. A 20 mm strap looks and sits better.
What lug width does a KOMPAS watch have?
All four models have a 20 mm lug width. Each ships with a 20 mm rubber strap and a 20 mm nylon strap, both quick release.
How do I measure lug width without callipers?
Hold a steel ruler flat and square across the gap between the lugs. Read it at eye level, then check the maker's specification to confirm.
Every model shares the same 20 mm lugs and two straps in the box. See the KOMPAS range.