Is Your Watch Magnetised? How to Check and Fix It

Updated

If your mechanical watch suddenly gains minutes a day, it is probably magnetised. Check it by moving it slowly around a compass. If the needle moves, an inexpensive demagnetiser or a quick visit to a watchmaker will fix it in minutes.

Magnetism is one of the most common reasons a healthy mechanical watch starts to misbehave. It is also one of the easiest problems to fix.

What magnetism does to a watch

The heart of a mechanical watch is the balance wheel and its fine hairspring. The spring's steady breathing sets the rate at which the watch runs.

When the hairspring is magnetised, its coils can cling to each other. That effectively shortens the spring, so the balance swings faster and the watch gains time. Magnetism can also upset how the spring copes with changes in temperature.

Other steel parts can pick up magnetism too, but the hairspring is the part most often affected.

The good news is that the effect is never permanent. The watch stays magnetised until it is treated. Demagnetising restores normal running, and the case does not need to be opened.

The Miyota 9039 in every KOMPAS runs at 28,800 vibrations per hour, or 4 Hz. A magnetised hairspring makes it beat faster than that, so every hour adds a little extra time.

Why it happens more often now

Magnets are everywhere in modern life. Phone cases, chargers, laptop lids and headphone cases often use small, strong magnets to snap shut or line up.

A watch once kept in a drawer now spends its day beside them. That makes magnetism one of the first things to rule out when a good watch suddenly runs fast.

Signs your watch is magnetised

  • It suddenly gains a lot of time, often several minutes a day.
  • The change appeared overnight or after a trip, not slowly over months.
  • The rate jumps around from one day to the next.
  • You recently left it on a laptop, beside a speaker or near a magnetic case.

Note the day you first noticed the change. It often points straight to the cause, such as a new phone case.

A few seconds a day either way is normal drift, not magnetism. A watch that stops, or runs down unusually fast, is more likely to need a service.

Common sources of magnetism

  • Phones, tablets and magnetic phone cases, mounts and chargers
  • Laptop lids, which often close with magnets, and laptop speakers
  • Speakers, headphones and earbud cases
  • Magnetic bag clasps, wallet catches and jacket fastenings
  • Induction hobs and the magnetic parts of fridges
  • Hairdryers and electric razors

Most of these are harmless at a normal distance. Trouble usually comes from resting a watch on or beside them for a while. A simple habit helps. Keep your watch a hand's width away from anything that snaps shut on its own.

The compass test

  1. Lay a simple compass on a table, away from metal objects, and let the needle settle.
  2. Take off the watch and bring it slowly towards the compass.
  3. Move it around the compass, about 1 to 2 cm away, at several angles.
  4. Watch the needle. If it twitches, swings or follows the watch, the watch is magnetised.
  5. If the needle stays still, magnetism is probably not the cause.

Test the watch before and after any fix, so you know it has worked.

A compass or magnetometer app on your phone can work too. Phones contain magnets of their own, so the readings can be noisy. A real compass gives a clearer answer.

How to use a demagnetiser

A basic demagnetiser is a small mains-powered box with a coil inside and a single button. It is inexpensive and easy to find from watch tool suppliers.

  1. Press and hold the button before the watch comes near the coil.
  2. Place the watch flat on the pad, or hold it just above it.
  3. Keep the button held and lift the watch away slowly and steadily, to about 30 cm.
  4. Release the button once the watch is well clear.
  5. Test again with the compass. Repeat once or twice if the needle still moves.

Some guides suggest letting the watch run down before you start. Others leave it running. Either way, take it off the wrist and keep the case closed.

Do not tap the button while the watch sits on the coil. Switching the field off up close can leave the watch more magnetised than before.

Afterwards, set the watch to the second and check it against your phone over a day or two. The rate should settle back to normal. If your watch hacks, setting it precisely is easy, as our note on hacking seconds explains.

When to see a watchmaker

If you would rather not do it yourself, a watchmaker can demagnetise a watch in a few minutes. Many charge little or nothing for the job.

See a watchmaker if the watch still runs fast after demagnetising, if it stops, or if the power reserve seems short. These point to a movement that needs attention. If the watch was dropped or knocked, stop wearing it and have it checked.

A watchmaker can also measure the rate on a timing machine. That shows at once whether the watch is back to normal or needs regulating.

Our guide to automatic watch care and servicing explains what a full service involves and how often to plan one.

Antimagnetic standards and prevention

The international standard ISO 764 sets the test for a magnetic resistant watch. It must withstand a field of 4,800 A/m, about 60 gauss, and still keep within 30 seconds a day.

Some brands go much further. Omega, for example, tests its Master Chronometer watches at 15,000 gauss. Most everyday watches make no such claim, so a little care goes a long way.

Magnetic fields fade quickly with distance, so a short gap makes a real difference.

If you work around strong magnets, in a lab or a workshop for example, consider a watch tested to a higher standard.

A KOMPAS, like most mechanical watches, is happiest away from strong magnets. If your North comes off at a desk, rest it a hand's width from the laptop, not on the lid.

  • Keep the watch away from speakers and headphones when you take it off.
  • Do not store it next to a phone or a magnetic case overnight.
  • Carry it away from magnetic bag clasps when it is off your wrist.
  • Keep it off wireless chargers and magnetic phone mounts.

Quartz watches react differently. A strong field can stop an analogue quartz watch or throw out its timing. Leftover magnetism does not affect its accuracy, so move it away and reset the time. Our comparison of automatic and quartz watches covers the other differences.

Frequently asked questions

How do I know if my watch is magnetised?

Move it slowly around a compass. If the needle twitches or follows the watch, it is magnetised. A sudden gain of minutes a day is the usual sign.

Can a phone magnetise a watch?

Yes, phones and especially magnetic cases, mounts and chargers can. Keep your watch a hand's width away when you put it down.

Does magnetism damage a watch permanently?

No. A magnetised watch keeps poor time, but demagnetising restores normal running without opening the case.

How much does it cost to demagnetise a watch?

Very little. A basic demagnetiser is inexpensive, and many watchmakers will do the job for a small fee or for free.

Can a quartz watch be magnetised?

A strong field can stop an analogue quartz watch or upset its timing. Once it is moved away and the time is reset, it usually runs normally again.

Every KOMPAS runs on the Miyota 9039 automatic and is built for daily wear. See the KOMPAS range.

Next
Next

What Is a Microbrand Watch, and Is One Worth Buying?