Automatic Watch Care (2026) – Servicing, Magnetism and Everyday Knocks

Updated · By Adventure Man

Most automatic watches need a full service every few years. Citizen's own manuals for its mechanical calibres say every two to three years, and independent guides usually quote three to five, depending on how hard the watch is worn. Between services, the things that matter most are keeping it away from strong magnets, avoiding hard knocks, rinsing it after salt water and having the seals checked before you rely on its water resistance.

None of this is complicated, and a well-made automatic is tougher than its reputation. This guide covers what a service is, how to tell when one is due, why magnetism is the most common fault and how to fix it, and the simple habits that keep a steel field watch in good shape.

What a service actually involves

An automatic movement is a set of small steel and brass parts running against each other on jewel bearings, with tiny amounts of oil at the friction points. Over the years that oil thickens, dries or migrates, and parts begin to wear. A service puts that right.

A full service (watchmakers often call it an overhaul) usually means taking the movement apart, cleaning every part, replacing worn ones, oiling and reassembling, then regulating the watch for accuracy. The case gaskets are normally replaced at the same time and the watch pressure-tested for water resistance.

How often should you service an automatic watch?

There is no single answer, and you will see different numbers quoted. Citizen, whose Miyota calibres include the 9039 inside every KOMPAS, recommends in its mechanical watch manuals that the movement is taken apart and cleaned (an overhaul) every two to three years. Independent guides generally describe three to five years as a baseline rather than a rule, and note that a watch worn hard every day may need attention sooner than one in a collection.

A practical approach – follow the maker's interval if you want the watch at its best, and in any case do not wait for it to stop. A watch that is running poorly is a watch whose parts are wearing faster than they should.

Gaskets are a separate question. Citizen recommends replacing them every two or three years, because rubber seals slowly harden. If you swim with your watch, have the seals checked and the watch pressure-tested at least that often, even if the movement itself is running well.

Signs your watch needs attention

Use this table to work out what is probably going on before you book anything. Some problems have a two-minute fix at home. Others need a watchmaker.

SymptomLikely causeWhat to do
Stops overnight or after a day off the wristRun out of power reserve (about 42 hours on a Miyota 9039 from full)Wind 15 to 20 turns by hand, set the time and wear it. Normal behaviour.
Suddenly gains minutes a dayMagnetised hairspringDo the compass test (below), then have it demagnetised. Most watch shops can do this quickly.
Gradually less accurate over months or yearsLubricants ageing. Due a serviceBook a service.
Stops while worn every dayMagnetism, a shock, or worn or dry partsCheck for magnetism first. If that is not it, take it to a watchmaker.
Crown feels gritty, stiff or looseDirt in the keyless works, or a bent stem after a knockStop winding and have it checked.
Rattling or grinding from insideLoose part, often after a dropStop wearing it and take it to a watchmaker straight away.
Mist under the crystalMoisture inside the case. Seal or crown not fully closedTake it in promptly, before rust sets in.

For reference, Miyota's specification sheet gives the 9039 a rate of −10 to +30 seconds a day, measured after a full wind. Small daily variations within that range are normal.

Magnetism – the most common fault

The hairspring at the heart of a mechanical movement is a very fine coiled spring. If it becomes magnetised, its coils can cling together, which shortens the spring and makes the watch run fast, sometimes by minutes a day. In bad cases the watch stops.

The international standard for basic magnetic resistance, ISO 764, asks a watch to withstand 4,800 A/m (roughly 60 gauss) and stay within ±30 seconds a day. That covers ordinary life, but plenty of everyday objects carry stronger magnets right at their surface.

Where it comes from

  • Mobile phones and tablets, and especially their magnetic cases and stands.
  • Laptop speakers, headphones and desktop speakers.
  • Magnetic clasps on handbags, camera bags and rucksacks.
  • Fridge doors, induction hobs, hairdryers and electric razors.

Most of these only matter at close range. The habit that prevents most cases is simple – do not rest your watch on your phone, laptop or speaker, and do not drop it into a bag pocket with a magnetic catch.

How to tell if your watch is magnetised

Take the watch off and hold it close to a compass (a real one or a compass app). Move it slowly around the compass. If the needle swings as the watch passes, the watch is magnetised. A watch that suddenly runs fast for no obvious reason is the other giveaway.

Demagnetising

Magnetism does not damage the watch permanently, and fixing it is usually quick. A watchmaker passes the watch through a demagnetiser, then checks it. You can buy cheap home demagnetisers, but used wrongly they can leave the watch more magnetised than before, so a watch shop is the safer route.

Shocks and everyday knocks

Modern movements have shock protection on the balance, the part most at risk, and normal life (clapping, a brush against a door frame, a bumpy bike ride) is fine. What is not fine is a drop onto a hard floor, or a sharp blow such as a hammer or golf club in your hand.

The KOMPAS sapphire crystal is very hard to scratch, but no crystal is unbreakable. If you are doing heavy work, take the watch off. After a drop, listen for rattles, check the time over the next day, and look for anything loose on the dial.

Cleaning the case and straps

Do this every few weeks, and always after the sea or a pool.

  1. Make sure the crown is pushed fully in.
  2. Take the strap off (see our quick-release strap guide).
  3. Rinse the case under lukewarm tap water. For grime around the lugs and caseback, use a soft toothbrush and a drop of mild soap.
  4. Rinse again and dry with a soft cloth.
  5. Wash the rubber strap the same way. Hand-wash the nylon strap in mild soapy water and let it air-dry.

The KOMPAS case is sandblasted stainless steel. Do not use metal polish or a polishing cloth on it – polishing adds shine, and on a matt finish that shows up as bright patches. Clean it, do not polish it.

Water – what to check

The KOMPAS is water resistant to 100 m, which covers swimming and snorkelling. Water resistance depends on the gaskets, though, and those age. Three habits keep it reliable.

  • Never operate the crown in water or while the watch is wet.
  • Rinse in fresh water after salt water or chlorine.
  • Avoid saunas and very hot baths, since sudden heat is hard on gaskets.

For more detail, read 100 m water resistance explained.

Storage

Store the watch dry, at room temperature and away from speakers and other magnets. The KOMPAS triangular presentation box is a good home for it. If you will not wear it for months, there is no need to keep it running – let it stop and wind it when you pick it up again.

Warranty and getting help

Every KOMPAS comes with a 2-year international warranty. If your watch shows any of the symptoms above in that time, contact us before taking it elsewhere.

Frequently asked questions

How often does an automatic watch need servicing?

Citizen's own manuals for its mechanical calibres recommend an overhaul every two to three years. Independent guides usually quote three to five years as a baseline. Daily, hard wear points to the shorter end.

How do I know if my watch is magnetised?

Hold it close to a compass and move it slowly. If the needle swings, it is magnetised. A watch that suddenly gains minutes a day is the other common sign.

Can magnetism permanently damage a watch?

No. A watchmaker can demagnetise it quickly, and the watch should return to its normal rate.

Can I polish a sandblasted steel case?

No. Polishing leaves shiny patches on a matt finish. Clean it with water, mild soap and a soft brush instead.

Do I need to have the seals checked if I swim?

Yes. Gaskets harden with age. Citizen recommends replacing them every two or three years, and a pressure test at the same time confirms the watch is still sealed.

What warranty does a KOMPAS have?

Every KOMPAS has a 2-year international warranty.

Built for daily wear and easy to look after – see the KOMPAS North.

Previous
Previous

How to Use a Watch as a Compass – The Sun Method, Step by Step

Next
Next

How to Change a 20 mm Quick-Release Strap – and Rubber vs Nylon