100 m Water Resistance Explained – What You Can Really Do (2026)

Updated · By Adventure Man

A 100 m water-resistance rating means the watch passed a pressure test equal to 100 metres of still water when it was new. It does not mean you can take it 100 metres down. In practice a 100 m watch is fine for rain, hand washing, swimming and snorkelling, but it is not a dive watch and should not be used for scuba diving.

Water resistance is one of the most misread numbers on a watch. The figure on the dial or caseback is a test pressure, not a promise about depth, and how you treat the watch matters as much as the rating. Here is what 100 m really means and what you can safely do with it.

What the rating actually measures

For everyday watches, water resistance is covered by the international standard ISO 22810, which replaced the older ISO 2281. It sets out how water-resistant watches are tested and how they may be marked. The number, whether written as 100 m, 10 bar or 10 ATM, describes a pressure the watch withstood in a test, given as the equivalent depth of still water.

That test happens in controlled conditions, on a new watch with fresh seals. It can be carried out with air rather than water, and the standard lets brands test a sample from a production run rather than every single watch. It is a fair check that the case is well sealed, but it is not a simulation of real life in the sea.

Water-resistant watch vs diver's watch

Dive watches have their own, much stricter standard. ISO 6425. A watch that meets it can carry the words "DIVER'S WATCH" followed by its rating. The main differences.

  • A diver's watch must be rated to at least 100 m.
  • Every watch is tested, not just a sample.
  • It is tested at 125% of its rated pressure, to allow for things like movement through the water and ageing seals.
  • It must pass extra checks, including salt-water exposure, temperature shock and strap strength, and it needs a way to time a dive and markings you can read in the dark.

So a 100 m water-resistant watch and a 100 m diver's watch are not the same thing, even though the number matches. If you plan to scuba dive, use a watch marked as a diver's watch, or a dive computer.

Why 100 m is not a depth limit

Real life is harder on a watch than the test, for three reasons.

  • Movement. Swimming strokes, diving into a pool or a wave hitting your wrist all create brief pressure spikes above the still-water figure.
  • Ageing seals. The rubber gaskets in the case, caseback and crown wear and harden over time. A watch that passed at 100 m when new may not pass today if the seals have never been checked.
  • Heat and chemicals. Hot water, soap, salt and chlorine all work on seals over time.

This is why brands publish activity guidance rather than telling you to go to the rated depth. The number is best read as a grade – a higher figure means a better-sealed case with more margin, not a depth you can visit.

What you can do at each rating

The table below reflects typical guidance from watch brands and summaries of the standards. Individual brands vary, so check your own watch's instructions too.

Activity30 m (3 bar)50 m (5 bar)100 m (10 bar)200 m (20 bar)
Rain and splashesYesYesYesYes
Hand washingYesYesYesYes
ShowerNoBest avoidedQuick, cool shower onlyQuick, cool shower only
SwimmingNoLight swimming in calm waterYesYes
SnorkellingNoNot advisedYesYes
Surfing, sailing, kayakingNoNot advisedYesYes
Scuba divingNoNoNoOnly if marked "DIVER'S WATCH"

Based on watch brands' published care guidance and summaries of ISO 22810 and ISO 6425, checked on 19 November 2026. Every rating assumes a watch in good condition with its crown fully closed.

Hot water, steam and soap

Heat is the quiet enemy of water resistance. Metal and rubber expand at different rates when they warm up, and a sudden change, such as going from a hot tub straight into a cold pool, adds stress. Saunas and steam rooms combine heat and moisture, which is the hardest test of all for seals.

Our advice for any watch, KOMPAS included – take it off for hot baths, hot tubs, saunas and steam rooms. A quick, cool shower is fine for a 100 m watch, but soap and shampoo wear seals over time, so the safest habit is to take it off. Don't hold a watch directly under a running tap or a pressure washer either. A strong jet can push water where a still pool would not.

Seals, the crown and the buttons

The crown is the most likely way in for water, because it is a moving part with a seal around its stem. A few habits protect it.

  • Before the watch gets wet, check the crown is fully closed – pushed all the way in, or screwed fully down if your watch has a screw-down crown.
  • Never pull out, wind or set the crown while the watch is wet or under water. The same goes for chronograph pushers.
  • Wind and set the watch with dry hands, then put it on.
  • After sea water or a chlorinated pool, rinse the watch in fresh, cool water and pat it dry with a soft cloth.

On a KOMPAS you hand-wind and set the time with the crown, so it is worth making a habit of checking that it is fully home each time you have set the watch. Our guide to winding and setting an automatic watch covers the routine.

Service checks

Water resistance cannot be guaranteed for ever, because seals age whether or not you swim. A watchmaker can pressure-test a watch quickly, usually without opening the case.

  • If you swim or snorkel with your watch regularly, have it pressure-tested once a year, ideally before the summer.
  • For a watch that only meets rain and the odd splash, a check every few years, or at each full service, is usually enough.
  • Always have it tested after any repair that has opened the case.
  • If you ever see mist or droplets under the crystal, stop wearing the watch in water and take it to a watchmaker straight away. Moisture inside harms the movement quickly.

For more on service intervals, see our guide to automatic watch care and servicing.

Straps for wet days

The case is only half the story. Leather straps do not like water, so for swimming choose rubber, which rinses clean and dries in minutes. Nylon copes with water too but stays damp for longer. Every KOMPAS comes with both a rubber strap and a nylon strap, on 20 mm quick-release bars, so you can switch to rubber before a swim without tools.

Where KOMPAS sits

Every KOMPAS, from the KOMPAS North to the West (red), is water-resistant to 100 m. In practical terms that means rain, hand washing, swimming, snorkelling and water sports are all fine, with the crown closed and the seals in good order. It is a field watch, not a dive watch, so leave it on the boat for scuba and keep it out of the sauna. If you are weighing up the categories, our comparison of field, pilot and dive watches explains what each is built for.

Frequently asked questions

Can I swim with a 100 m water-resistant watch?

Yes. A 100 m rating is suitable for swimming, snorkelling and most water sports, as long as the crown is fully closed and the seals are in good condition. Don't operate the crown in the water.

Can I scuba dive with a 100 m watch?

Not unless it is certified as a diver's watch under ISO 6425 and marked "DIVER'S WATCH". A standard 100 m water-resistant watch is not designed or tested for scuba diving.

Can I wear my watch in the shower?

A 100 m watch will cope with a quick, cool shower, but hot water, steam, soap and shampoo all age the seals. Taking it off is the safest habit, and it should always come off for hot baths, hot tubs and saunas.

What is the difference between 100 m, 10 bar and 10 ATM?

They describe the same rating in different units. Ten bar, or ten atmospheres, is roughly the pressure of 100 metres of still water.

How often should water resistance be checked?

Once a year if you swim with the watch regularly, and every few years or at each service if it rarely gets wet. Always have it checked after the case has been opened.

Is a KOMPAS a dive watch?

No. KOMPAS is an automatic field watch with 100 m water resistance, which is plenty for swimming and snorkelling. For scuba diving, use a certified diver's watch or a dive computer.

Shop the four KOMPAS field watches, each water-resistant to 100 m

Previous
Previous

How to Read the 13–24 Track on a Field Watch Dial

Next
Next

Sapphire vs Mineral vs Acrylic – Watch Crystals Explained (2026)